Materials & Part Design

Guides to plastic materials and molded-part design, including polymer comparisons, resin selection, draft, wall thickness, ribs, threads and shrinkage. Relate material behavior and geometry to the requirements of your component.

High temperature injection molding of PEEK parts with a heated mold
October 5, 2026

High Temperature Injection Molding: Materials and Molds

High temperature injection molding: PEEK, PPS, LCP and PPA, heat measures, processing, mold building, part design and specifying heat needs….

Read More…

Plastic threaded inserts installed in a molded electronics housing
October 4, 2026

Plastic Threaded Inserts: Types, Installation and Bosses

Plastic threaded inserts: why use them, heat-set, ultrasonic and press-in types, installation, boss design, suitable plastics, tests and specs….

Read More…

Chemical resistance of plastics tested with molded parts in chemical baths
October 3, 2026

Chemical Resistance of Plastics: Chart and Stress Cracking

Chemical resistance of plastics: attack mechanisms, a resistance chart, stress cracking under load, temperature and molding effects and testing….

Read More…

HDPE vs Delrin parts compared: white HDPE strips and precision POM gears
September 29, 2026

HDPE vs Delrin: How to Pick the Best One and Save Money

HDPE vs Delrin: strength and stiffness, wear and friction, chemical resistance, molding and machining behavior, cost and how to choose….

Read More…

Creep deformation test: plastic bars under constant load in a heated chamber
September 26, 2026

Creep Deformation in Plastics: Causes and Design Tips

Creep deformation in molded plastic parts: creep vs stress relaxation, drivers, creep-resistant materials, design rules, snap-fit arms and testing….

Read More…

Izod vs Charpy impact test: pendulum impact tester in a plastics lab
September 25, 2026

Izod vs Charpy Impact Test: How to Pick the Best One and Save Money

Izod vs Charpy impact test: setup and standards, reading impact data, impact-resistant plastics, modifier trade-offs and testing molded parts….

Read More…

How to do a tolerance stack up analysis: engineer measuring a molded assembly gap
September 24, 2026

How to Do a Tolerance Stack Up Analysis: The Best Way to Save Time and Money

How to do a tolerance stack up analysis for molded assemblies: CTQ, dimension loop, worst case vs RSS, molded-part factors and reducing the stack….

Read More…

Heat staking plastic: heated tips forming studs over a PCB in a molded housing
September 23, 2026

Heat Staking Plastic: Methods, Stud Design and Materials

Heat staking plastic: methods, stud design, materials, process control and testing, compared with ultrasonic, spin and hot plate welding and marking….

Read More…

Living hinge design: polypropylene flip-top caps and a hinged box
September 22, 2026

Living Hinge Design: Materials, Geometry and Gating

Living hinge design for injection-molded parts: PP material choice, hinge geometry, gating and flow, molding, first flex and cycle testing….

Read More…