Injection Molds

Injection mold engineering guides covering cavity and runner choices, mold materials, cooling, surface specifications, maintenance and inspection. Use these articles to understand tooling decisions before specifying a custom mold.

Overmold tooling: open overmold tool with a rigid substrate part seated in the cavity
September 10, 2026

Overmold Tooling: Substrate Location, Shutoffs and Flash

Overmold tooling guide: substrate location, shutoff design, flash control, venting, bonding and what to check at overmold tool trials….

Read More…

Valve gate injection molding: hot runner mold half with valve gate nozzles and actuators

Valve Gate Injection Molding: Sequencing and Shutoff

Valve gate injection molding: needle sequence control, shutoff design, gate witness, multi-cavity sequence validation and valve gate maintenance….

Read More…

Mold bases for short production runs: standard mold base with removable cavity inserts on the bench
September 9, 2026

Mold Bases for Short Production Runs: How to Pick the Best One and Save Money

Mold bases for short production runs: aluminum vs steel bases, press data, removable inserts, insert interchangeability and fit inspection….

Read More…

Injection molding lifter: angled lifter raised from the core of an open mold
September 8, 2026

Injection Molding Lifter: Angle, Clearance and Wear

Injection molding lifter design: when to use a lifter, angle and travel calculation, clearances, drag marks, wear checks and lifter materials….

Read More…

Side action injection molding: opened mold with an angle-pin slide pulled back from the core
September 7, 2026

Side Action Injection Molding: Slides, Travel, Shutoffs

Side action injection molding: slide and lifter types, slide travel, shutoff and locking design, appearance, maintenance access and when to avoid slides….

Read More…

Multi cavity injection molding: eight-cavity mold core half with molded parts on the bench
September 6, 2026

Multi Cavity Injection Molding: How to Pick the Best Count

Multi cavity injection molding: how to calculate cavity count, part and mold cost trade-offs, press limits, mold layout, cavity balance and trial acceptance….

Read More…

Parting line injection molding: opened mold halves showing the parting surface around a molded part
September 5, 2026

Parting Line Injection Molding: How to Pick the Best Spot

Parting line injection molding guide: placement for appearance, flash risk, flat vs stepped lines, draft and slides, drawing notes and air ejection….

Read More…

Ejector pin marks: round witness marks on the inside ribs of a molded grey plastic housing
September 4, 2026

Ejector Pin Marks: Causes and How to Prevent Them

Ejector pin marks explained: what causes them, how ejector pin layout hides them, pin height and clearance, process fixes and drawing notes for buyers….

Read More…

Stack mold lifted by an overhead crane in a tooling workshop, showing two parting lines
September 3, 2026

Stack Mold: How to Get the Best Output Without Waste

Stack mold guide: how two-level molds work, which parts suit them, press daylight checks, hot runner design, maintenance access, risks and quote inputs….

Read More…